Elevate electrically height-adjustable office desk
Mounting aid ofinto Elevate
Here you can find videos on the functions of the ofinto Elevate
Assembly
Scope of delivery
A. Support bar
B. Table legs
C. Table legs
D. Side profiles
E. Table top
F. Power supply unit
G. Mains cable
H. Control element
I. Hexagon socket wrench 4mm
J. Screws M6*12mm
K. Screws M6*14mm
L. Spring washers
M. Washers
N. Rubber damper
O. Plastic protection
P. Screws ST4.8*25mm
Q. Screws ST4.8*19mm
R. Screws ST3.5*19mm
S. Cable holder, self-adhesive
Step 1
Step 2
Step 3
Step 4
Step 5
Step 6
Step 7
Step 8
Functions
Initialization
When using the ofinto Elevate for the first time, the system must be initialized. To do this, hold down the ⇑ and ⇓ buttons simultaneously until the table has reached its lowest possible height and you hear a short pip tone (lasts about three seconds).
Adjusting the table height
The control element allows you to adjust the table height to the centimeter using the ⇑ and ⇓ buttons. The display shows you the current height of the tabletop.
Memory function
You have the option of saving up to four table positions for later use. To do this, use the arrow buttons to set the desired height and then press and hold the M button until the number on the display starts to flash. Now press buttons 1, 2, 3 or 4 to save the current table position under this button. The height remains stored even if the table is temporarily without power.
Altitude display
The control element display shows the current height of the tabletop. This display works in both centimetres and inches. To change the display, press and hold buttons 1, 2 and M simultaneously until "C-E" flashes on the display. Now press button 1 for CM or button 2 for inches within five seconds.